When partial quantity of a TO or PO line is added to a voyage/container via the voyage editor, the transfer line is split or purchase order line delivery schedule is created

Example below:

• Original TO line = 20 pieces
• 10 pieces added to voyage 000104
• TO line 1,5 is created = 10 pieces
• TO line 1 is reduced to 10
• 5 pieces added to voyage 00111
• TO line 1,25 is created = 5 pieces
• TO line 1 is reduced to 5

This however is not possible via following entities:

• Voyage transfer lines - ITMTransferLinesEntity
• Voyage purchase lines - ITMPurchaseLinesEntity

You receive following error:

A row created in data set LandedCostTransferLines was not published. Error message: 'Write failed for table row of type 'ITMTransferLinesEntity'. Infolog: Error: Voyage lines quantity does not match the transaction quantity for line 5,00 on Transfer order receive..'

Feedback MS support:

• Similar issue was reported in LCS Issue 785142 - Voyage purchase lines entity cannot accept to upload same purchase line in 2 different shipping containers where the product group explained that “By design. One purchase can only be in one container. For manual creation, after a partial of the purchase line is tranferred to a container (please to to purchase order form and refresh to observe the result), the remain quantity will be split into a new line. the new line can be added to another container.”
• I also reached to the product group to check the scenario in our ticket as we are not adding the PO line or TO line to two containers but we are adding partial quantity into a container, and the product group confirmed that this is not supported scenario and that the Data entity only import the data and will not split the order line.