-
D365 GUIDES 3D GIZMO(PIVOT?) function proposal.
Hello. I'm suggesting the GIZMO function because there's something uncomfortable I felt when I was mapping on the spot. When I map a 3D modeling or 3D toolkit to a real object, it is quite difficult to place it depending on the direction I see when placing it from a slightly distant location. I want to adjust only the left and right directions, but as soon as I hold the hologram, it moves little by little in the front and back directions, so the mapping position often goes wrong again. Therefore, if there is a GIZMO function like a modeling tool such as 3D MAX or Blend with some position, it will be easier to map in the field by shortening time. Please review it. -
GUIDES hologram lock function
Hello.
It would be nice to have a lock function after placing the hologram in GUIDES. This is because there is a case where the hologram A is first placed and then the hologram B, which is smaller than A, is tried to be placed in a similar position, but touch A and move from the initial position.
-
GUIDES Hologram GIZMO(X, Y, Z) Features
Hello.
I use GUIDES quite a bit in a real factory.
When mapping a hologram from a distance to an air tap in GUIDES, if there is GIZMO (X, Y, Z), it will be much easier, faster and more accurate.
Please consider that feature.
Thank you.
You’re offline. This is a read only version of the page.
