At the moment what you have to do to connect accounts to a sequence is:

1. open sequence
2. click on tab "connected accounts"
3. click "connect accounts"
4. choose view
5. mark accounts and click "connect"

When you're done with the first page, you have to do steps 3-5 again for every page as well as:

6. navigate to next page

When clicking to navigate to the next page it takes 6 seconds to reach the next page. If you have 10 pages (which is a low number for us), you're clicking next page 45 times in total and you spend 4.5 minutes just for clicking to the next pages (in addition to all the other steps you have to do for every single page).

2 things should be improved:

1. When choosing the view you shouldn't have to search it in the list manually. You can misclick easily when you have lots of views, you may not notice it and connect the wrong accounts. It is then difficult to figure out on which page the mistake was made. There should be a field where you can type the name of the view to narrow down the list, just like in the Account entity.
2. Ideally, after connecting a page is finished, you should not be pushed back to step 3 but still be on the last page of the view you were on. If that is not possible there should be a field where you can type the number of the page you want to navigate to. If that is also not possible there should at least be a button that brings you to the last page. There is a button that brings you to the first page, should be possible for the last page too.