When all bookings of a requirement are completed, the work order will get status Open - Completed. Nevertheless, the requirement of the work order is still Active. In case a work order was executed in less time than planned, the remaining duration will still be >0. The combination of the 'active' requirement and remaining duration > 0 and work order Open - Completed, still allows you to schedule the remaining duration of the requirement.This may lead to the situation that by mistake a work order which has been completed but still has remaining duration can be scheduled again. OOTB a requirement is set to Completed when the work order is set to Closed - Posted. In most cases that status is just reached after longer period time because back office need to check all transactions before finally closing a work order. So the 'completion' of the require,ent triggered by Closed Posted action comes for much customers too late. It would be very nice if a way can be implemented to auto complete a requirement when the bookings of the requirement are completed. That will prevent users to schedule remaining durations which should not be schedule anymore. For example: - Parameter 'auto complete requirement' on booking status X in the Booking Setting Metadata - Or a parameter 'auto complete requirement' on Work Order Type Note there could be multiple bookings on 1 requirement. All bookings should be comlpleted in order to complete the related requirement